HLCL
Configuration file Custom
Components ???
Unique footprints ???
Families 3

Walk through the nine steps. Settings persist in this browser between visits.

Presets

Start from a known-good combination of vendor families, IPC tolerances, and build outputs. Every preset overlays on top of factory defaults — applying a preset overwrites the Libraries, Settings, and Build tabs but leaves your cross-links untouched.

Custom Edits in any later tab will mark the configuration as “custom”.
|

Consumer / commercial

Cost-optimised

Mainstream commercial passives at the lowest BOM cost. Loose-but-IPC-compliant pad math; full density-variant set so the routing engineer keeps options. Families not listed here ship disabled (toggle them on individually in the Libraries tab if needed).

  • Panasonic ERJ thick-film resistors (commodity, 01005–0805)
  • Samsung CL + Murata GRM commercial MLCC for multi-source pricing
  • Murata BLM ferrite beads + LQM multilayer chip inductors
  • Default IPC tolerances (F = 0.10 mm, P = 0.05 mm); HLCL standards unchanged
  • .PcbLib + .DbLib + STEP packaged; no standards PDF
Vendor families
5 / 17 on

Automotive · AEC-Q200

AEC-Q200 / Q101

Automotive-qualified passives only — Murata GCM and TDK CGA capacitors paired with Panasonic ERJ and Yageo AC thick-film resistors. Tighter F/P tolerances reflecting a pre-qualified assembly line. Density variant N picked across the board. Other families ship disabled in this preset; turn them on individually if your part list demands it.

  • Murata GCM + TDK CGA automotive-qualified MLCC
  • Panasonic ERJ + Yageo AC AEC-Q200 thick-film resistors
  • Murata BLM chip ferrites for power-rail filtering
  • F = 0.075 mm, P = 0.035 mm (qualified placement line)
  • Solder-mask sliver bumped to 0.12 mm for AEC pads
Vendor families
5 / 17 on

Everything · the kitchen sink

All families

Every vendor family this build chain knows about, every density variant, every artifact (including both standards renderings). Slowest preset to build; biggest output set.

  • All 17 family generators turned on (resistors, MLCC, ferrites, inductors)
  • L / N / M density variants emitted everywhere
  • Standards .tex + .md + house.SchLib + house.PcbLib all packaged
  • Useful as a regression baseline
Vendor families
17 / 17 on
Tip: Presets are a starting point — you can fine-tune anything they set on the later tabs. Once you do, the badge at the top will switch to Custom configuration.